Inside the car, gently pry up the shifter boot and lift it over the shift knob, then lift up the insulator underneath the shift boot.When properly engaged, the pin will stay in place and you will not be able to move the selector shaft.
Push in on the locking pin and gently move the selector shaft up and down until the pin engages the alignment hole in the selector shaft and pushes into the transmission (you may need to turn the locking pin slightly as you push it into the transmission).With the transmission in neutral, push down on the top of the selector shaft until it is approximately in the middle of its travel. Locate the selector shaft locking pin in the transmission housing (just beneath the shifter assembly).It is properly locked when you release your grip and the spring remains compressed.Grasp the knurled round end of the cable lock and pull it forward until the spring is completely compressed, then turn it about 1/8 of a turn to the left to lock it into place.
#Mk4 jetta o2j shifter cable ends install#
#Mk4 jetta o2j shifter cable ends pdf#
Introduction: Click HERE for printable PDF